Black out the face of your factory rear GT badge without removing the emblem from the vehicle.
This gloss black vinyl overlay is precision-cut to install directly over the factory-installed rear GT emblem found on 2015–2023 GT models. The overlay applies to the face of the badge while keeping the original emblem intact underneath.
Manufactured in-house using automotive-grade vinyl with air-release adhesive technology, each overlay is test-fit to ensure proper alignment and clean installation results. If it doesn’t meet our internal fitment standards, it doesn’t ship.
This is a simple peel-and-apply styling upgrade that delivers a darker, more aggressive rear appearance without the cost or hassle of replacing the factory emblem.
What’s Included:
• (1) Rear GT badge overlay
Installation Overview
Tools Recommended:
• Felt-edge squeegee
• Heat gun (or warm sunlight for post-heating)
Surface Preparation:
Thoroughly clean the emblem surface before installation. Remove wax, dirt, and debris to ensure proper adhesion. A clay bar treatment is highly recommended. Install between 65°F–90°F and avoid direct sunlight or extreme temperatures during application.
Application Steps:
Remove the overlay from the backing paper.
Align the center of the overlay with the gap between the “G” and “T” on the factory badge.
Once centered, apply firm pressure vertically through the center of the emblem, then horizontally outward.
Slowly remove the transfer tape.
Post-heat using sunlight (approximately 30 minutes) or a heat gun to activate the adhesive.
Product Features:
• Automotive-grade adhesive vinyl
• Air-release technology for bubble-free installation
• Car wash safe
• Removes cleanly without damaging the emblem
• 2-5 year outdoor durability
• Designed and produced in the USA
• Difficulty Rating: 1/5 (Beginner Friendly)
Note: Always verify fitment using our vehicle selector above before purchasing.
$132.00