Black out the face of your factory 5.0 side emblems without removing the badge from the vehicle.
This gloss black vinyl overlay kit is precision-cut to install directly over the factory 5.0 fender badges found on 2015–2023 GT 5.0 models. The overlay applies to the face of the emblem while keeping the original badge structure intact underneath.
Manufactured in-house using automotive-grade vinyl with air-release adhesive technology, each overlay is test-fit to ensure proper alignment and clean results. If it doesn’t meet our standards during real-world testing, it doesn’t ship.
This is a fast, peel-and-apply styling upgrade that delivers a darker, more aggressive appearance without the cost or hassle of badge replacement.
What’s Included:
• Driver side 5.0 overlay
• Passenger side 5.0 overlay
Installation Overview
Tools Recommended:
• Felt-edge squeegee
• Heat gun (or warm sunlight for post-heating)
Surface Preparation:
Thoroughly clean the emblem surface before installation. Remove any wax, dirt, or debris to ensure proper adhesion. A clay bar treatment is highly recommended. Install between 65°F–90°F. Avoid direct sunlight and extreme temperatures during application.
Application Steps:
Remove the overlay from the backing paper.
Align the center section with the recessed center of the factory 5.0 badge.
Apply firm pressure vertically through the center, then horizontally from the middle outward.
Slowly remove the transfer tape.
Post-heat using sunlight (approximately 30 minutes) or a heat gun to properly activate the adhesive.
Product Features:
• Automotive-grade adhesive vinyl
• Air-release technology for bubble-free install
• Car wash safe
• Removes cleanly without damaging the badge
• 2–5 year outdoor durability
• Designed and produced in the USA
Note: Always verify fitment using our vehicle selector above before purchasing.
$132.00