2022 SUBARU WRX | INNER TAIL LIGT TINT OVERLAY - SMOKE TINT

Give your 2022 Subaru WRX tail lights a darker, more distinctive appearance with our Red Inner Tail Light Tint Overlays. These vehicle-specific overlays cover the inner turn-signal and reverse-light sections, creating a clean custom look without permanently modifying the factory tail lights.

This two-piece kit is precision-cut from premium automotive-grade tint film for straightforward installation and accurate fitment. The dramatic appearance, beginner-friendly installation and reversible design make this one of the easiest ways to personalize the rear of your WRX.

What’s Included

• One driver-side red inner tail light overlay
• One passenger-side red inner tail light overlay
• Complete two-piece vehicle-specific kit

Features & Specifications

• Fits 2022 Subaru WRX
• Covers the inner turn-signal and reverse-light sections
• Red-tint finish
• Causes the factory reverse light to emit a red glow
• Includes driver-side and passenger-side overlays
• Complete two-piece kit
• Precision-cut premium automotive-grade film
• Adhesive-backed film for straightforward installation and removal
• Maintenance-free and automatic-car-wash safe after fully cured
• Removes without permanently damaging the factory lenses
• Estimated outdoor durability of 2–5 years depending on climate, exposure, installation and maintenance

Wet Installation Guide

Wet installation makes it easier to accurately position each overlay before securing it. Experienced installers may install the film dry, but wet installation is recommended for most first-time DIY customers.

Step 1: Prepare the Tail Lights

Thoroughly clean each inner tail light to remove dirt, road film, wax, ceramic products and other contaminants. Use a clay bar when necessary, then complete the final cleaning step with a vinyl-safe surface-preparation solution. The lenses must be completely clean before installation.

Step 2: Check the Installation Conditions

Work in a clean, shaded and temperature-controlled environment. Never apply the overlays in direct sunlight or to hot, cold or wet lenses. For the best results, install between 65°F and 80°F. Installation may be possible between 50°F and 90°F, but additional care may be required.

Step 3: Prepare the Slip Solution

Use Premium Surface Lube or another vinyl-safe slip solution. If a professional solution is unavailable, mix approximately 16 ounces of clean water with one small drop of mild dish soap. Use only a fine mist—less solution is better for this installation.

Step 4: Identify and Position the Overlays

Identify the driver-side and passenger-side pieces before removing the backing. Lightly mist the lens and adhesive side of the film, then position the overlay over the inner turn-signal and reverse-light section. Confirm the perimeter alignment before securing the film.

Step 5: Squeegee the Film

Hold the overlay in position and begin squeegeeing from the center toward the outer edges. Use controlled, overlapping strokes to push the slip solution and trapped air out from beneath the film.

Step 6: Conform and Secure the Edges

Apply gentle heat where necessary to soften the film and help it conform around bends, corners and lens contours. Avoid overheating or overstretching the material. Continue removing moisture and firmly press every edge once alignment is complete.

Step 7: Inspect and Allow to Cure

Inspect both overlays for trapped moisture, air pockets or unsecured edges. Allow the vehicle to remain in a warm, dry environment while the remaining moisture evaporates. Avoid washing the vehicle or exposing the overlays to unnecessary moisture for at least 24 hours.