2022 SUBARU WRX | OUTER TAIL LIGT TINT OVERLAY - SMOKE TINT

Give your 2022–2026 Subaru WRX a darker, cleaner rear-end appearance with our precision-cut Full Tail Light Tint Overlays in Medium Smoke. This complete four-piece kit covers the red parking and brake-light lenses along with the clear turn-signal lenses, reducing the amount of bright red and clear plastic visible across the rear of your WRX.

The medium-smoke finish creates a more unified and aggressive appearance while preserving the recognizable factory tail-light design. Each overlay is computer-cut from premium automotive-grade tint film, test-fitted and produced at our California facility for dependable vehicle-specific fitment and straightforward DIY installation.

What’s Included

• Driver-side red-lens tail-light tint overlay
• Passenger-side red-lens tail-light tint overlay
• Driver-side clear turn-signal lens tint overlay
• Passenger-side clear turn-signal lens tint overlay

Features & Specifications

• Fits 2022–2026 Subaru WRX factory tail lights
• Medium-smoke automotive tint-film finish
• Covers the rear red and clear tail-light lens sections
• Includes driver-side and passenger-side overlays
• Complete four-piece kit
• Precision-cut for vehicle-specific fitment
• Adhesive-backed film for installation and removal
• Low-maintenance and car-wash safe after fully cured
• Removable without permanently modifying the factory lenses
• Estimated service life of 2–5 years depending on climate, exposure, installation and maintenance

Wet Installation Guide

A wet installation is recommended because it allows the film to be repositioned during alignment. Experienced installers may also apply these overlays dry. Use only a fine mist of slip solution, as excessive solution can extend the drying time and make the edges more difficult to secure.

Step 1: Prepare the Tail Lights

Thoroughly clean each tail-light lens to remove dirt, road film, wax, ceramic products and other contaminants. Use a clay bar when necessary, then complete the final cleaning step with a vinyl-safe surface-preparation solution. The lenses must be completely clean before beginning the installation.

Step 2: Check the Installation Conditions

Work in a clean, shaded and temperature-controlled environment. Never apply the overlays in direct sunlight or to hot, cold or wet lenses. For the best results, install between 65°F and 80°F. Installation may be possible between 50°F and 90°F, but additional care may be required.

Step 3: Prepare the Slip Solution

Use a vinyl-safe surface slip solution. If a professional solution is unavailable, mix approximately 16 ounces of clean water with one small drop of mild dish soap. Use only a fine mist—less solution is better for this installation.

Step 4: Identify and Position the Overlays

Identify all four pieces and match each one to its corresponding driver-side or passenger-side lens section. Lightly mist the lens and adhesive side of the overlay, then position the film and carefully confirm its alignment before securing it.

Step 5: Squeegee the Film

Hold the overlay in position and begin squeegeeing from the center toward the outer edges. Use controlled, overlapping strokes to push the slip solution and trapped air out from beneath the film.

Step 6: Conform and Secure the Edges

Apply gentle heat where necessary to soften the film and help it conform around bends, corners and lens contours. Avoid overheating or overstretching the material. Continue removing moisture and firmly press all edges once alignment is complete.

Step 7: Inspect and Allow to Cure

Inspect each completed overlay for trapped moisture, air pockets or unsecured edges. Allow the vehicle to remain in a warm, dry environment while the remaining moisture evaporates. Avoid washing the vehicle or exposing the overlays to unnecessary moisture for at least 24 hours.