Smoked Tail Light Overlays | 2017-2020 SUBARU BRZ & TOYOTA GT86
- SHOP BY VEHICLE
- SHOP BY PRODUCT
- NEW PRODUCTS
- BEST SELLERS
- UNIVERSAL
- VIDEO GUIDES
- MORE
SMOKED TAIL LIGHT OVERLAYS
Give your BRZ or GT86 a clean, aggressive look with Premium Auto Styling smoked tail light overlays. Precision cut from LUXE Mid-Smoke air-release tint vinyl, this two-piece kit adds a smoked appearance without replacing your tail lights.
The film’s air-release adhesive helps trapped air escape during installation, while heat allows the material to conform around bends and curves. This product installs dry—do not use water, soap, or application solution.
QUICK INSTALL GUIDE
Thoroughly clean the tail lights and dry them completely. Remove any wax, grease, or residue before installation.
Peel the overlay from its backing and carefully align it on the tail light.
Using a felt-edge squeegee, apply light, overlapping strokes from the center outward to press the film into place and release trapped air.
Gently warm the film with a heat gun as needed to help it conform around curves. Avoid overheating or overstretching the material.
Follow the film manufacturer’s post-heating instructions, then check that all edges are securely adhered.
Allow approximately 30 minutes for installation. Installation time may vary with experience.
FEATURES & SPECIFICATIONS
LUXE Mid-Smoke tint vinyl
Air-release adhesive for dry installation
Precision-cut driver and passenger side overlays
Two-piece kit
Application: 2017–2020 Subaru BRZ and Toyota GT86
Heat-conformable film for bends and curves
Adhesive-backed overlays applied over your existing tail lights
NOTE: A felt-edge squeegee is highly recommended and is available in our application tool section. A heat gun is also recommended for shaping and post-heating the film.
Note: Always verify fitment using our vehicle selector above before purchasing.
★★★★★
fits perfect and look amazing
It is recommended that someone install it with a bit of experience
A little difficult to install but once you have the technique down they look really good would definitely buy again
Tough--at least putting it on. Can't comment on longevity yet. I have put a ton of wrap (colored, carbon fiber 3M etc) on some pretty difficult bends. This was tougher. The pre-cut shape was perfect, & well protected when mailed. But when I warmed it to stretch/shrink, it crinkled and dried much more than I was used to. I wish I had practice pieces. Given experience it would likely be perfect. I gave a 4 stars since even with moderate experience, it was still hard to get on perfectly.
Installation was straight forward, but positioning it was a bit hard. I ended up ripping one accidentally trying to get the water worked out of it probably gonna need to order them again
