2022-2023 SUBARU WRX | INNER TAIL LIGHT TURN SIGNAL TINT OVERLAY - SMOKE TINT

Give your 2022–2026 Subaru WRX tail lights a darker, more unified appearance with our Inner Tail Light Turn Signal Tint Overlays in Premium Red Tint. These overlays cover the inner turn-signal sections to reduce the contrasting factory appearance and create a cleaner, red-on-red tail-light design.

This two-piece kit includes precision-cut overlays for both the driver-side and passenger-side tail lights. Each piece is manufactured from premium automotive-grade red tint film for vehicle-specific fitment, a noticeable visual transformation and an easy, beginner-friendly installation.

What’s Included

• One driver-side inner tail-light turn-signal tint overlay
• One passenger-side inner tail-light turn-signal tint overlay
• Complete two-piece vehicle-specific kit in Premium Red Tint

Features & Specifications

• Designed for 2022–2026 Subaru WRX models
• Covers the inner tail-light turn-signal sections
• Creates a darker, more unified red tail-light appearance
• Premium Red Tint automotive film
• Includes driver-side and passenger-side overlays
• Complete two-piece vehicle-specific kit
• Precision-cut premium automotive-grade film
• Adhesive-backed film for straightforward installation and removal
• Designed for wet installation; experienced installers may install dry
• Maintenance-free and automatic-car-wash safe after fully cured
• Removable without permanently modifying the factory tail lights
• Estimated outdoor durability of 2–5 years depending on climate, exposure, installation and maintenance

Wet Installation Guide

Wet installation is recommended for first-time installers because the surface lube allows each overlay to be repositioned before the adhesive is fully secured. Experienced installers may also install this product dry.

Step 1: Prepare the Tail Lights

Thoroughly clean the application areas to remove dirt, road film, wax, ceramic products and other contaminants. Use a clay bar when necessary, then complete the final cleaning step with a vinyl-safe surface-preparation solution. Allow the tail lights to dry completely.

Step 2: Check the Installation Conditions

Work in a clean, shaded and temperature-controlled environment. Never apply the overlays in direct sunlight or to hot, cold or wet tail lights. For the best results, install between 65°F and 80°F. Installation may be possible between 50°F and 90°F, but additional care may be required.

Step 3: Prepare the Surface Lube

Use Premium Surface Lube or prepare a mild solution using approximately 16 ounces of clean water and one drop of dish soap. Excess soap may reduce initial adhesion and increase drying time, so use only the recommended amount.

Step 4: Identify and Test-Fit the Overlays

Identify the driver-side and passenger-side pieces before removing them from the backing paper. Test-fit each overlay over the corresponding inner turn-signal section to understand its alignment and orientation.

Step 5: Mist and Position the Film

Remove the overlay from its backing and apply a fine mist of surface lube to the adhesive side. Less is better. Position the film over the turn-signal section and carefully slide it into the correct location.

Step 6: Squeegee Out the Solution

Once the overlay is aligned, hold it in position and begin squeegeeing from the center toward the outer edges using controlled, overlapping strokes. Push the surface lube and trapped air completely out from beneath the film.

Step 7: Conform and Secure the Film

Apply gentle heat when necessary to help the film conform to bends, edges and tail-light contours. Avoid overheating or overstretching the material. Continue squeegeeing until the film is smooth and all edges are securely adhered.

Step 8: Inspect and Allow to Dry

Inspect both overlays for trapped moisture, air pockets, wrinkles or unsecured edges. Allow the vehicle to remain in a warm, dry environment while the adhesive sets. Gentle finishing heat may be used to help accelerate the drying process.