2022 Subaru WRX | WRX Premium Headlight Amber Delete - Gloss Black

Give your 2022+ Subaru WRX headlights a cleaner, more aggressive appearance with our Headlight Amber Delete Overlays in Gloss Black. These precision-cut overlays conceal the factory amber reflectors to create a streamlined, blacked-out front-end appearance without permanently modifying the factory headlights.

This two-piece kit includes vehicle-specific overlays for both the driver-side and passenger-side headlights. Each piece is computer-cut from premium automotive-grade gloss-black wrap film for accurate fitment and a straightforward, beginner-friendly dry installation.

What’s Included

• One driver-side headlight amber-delete overlay
• One passenger-side headlight amber-delete overlay
• Complete two-piece vehicle-specific kit in Gloss Black

Features & Specifications

• Fits 2022+ Subaru WRX Base and Premium trim levels only
• Does not fit WRX Limited or GT models
• Covers the factory amber headlight reflectors
• Gloss Black High-Performance Wrap Film
• Includes driver-side and passenger-side overlays
• Complete two-piece vehicle-specific kit
• Precision-cut premium automotive-grade film
• Adhesive-backed film for straightforward installation and removal
• Maintenance-free and automatic-car-wash safe after fully cured
• Removable without permanently modifying the factory headlight lenses
• Estimated outdoor durability of 2–5 years depending on climate, exposure, installation and maintenance

Dry Installation Guide

This product is designed for dry installation. Do not spray the adhesive or headlight with a slip solution. Carefully position and anchor the overlay before gradually applying it to the factory lens.

Step 1: Prepare the Headlights

Thoroughly clean both headlights to remove dirt, road film, wax, ceramic products and other contaminants. Use a clay bar when necessary, then complete the final cleaning step with a vinyl-safe surface-preparation solution. The headlight lenses must be completely clean and dry before installation.

Step 2: Check the Installation Conditions

Work in a clean, shaded and temperature-controlled environment. Never apply the overlays in direct sunlight or to hot, cold or wet headlights. For the best results, install between 65°F and 80°F. Installation may be possible between 50°F and 90°F, but additional care may be required.

Step 3: Identify the Overlays

Identify the driver-side and passenger-side pieces before removing them from the backing paper. Test-fit each overlay over the corresponding amber reflector to understand the alignment and orientation.

Step 4: Position and Anchor the Film

Peel back a small portion of the backing and carefully position the overlay over the amber reflector. Check the alignment along the factory lens before lightly anchoring one section of the film. Avoid firmly pressing the entire overlay down until you are satisfied with its position.

Step 5: Apply the Overlay

Once aligned, begin squeegeeing from the anchored area toward the outer edges using controlled, overlapping strokes. Gradually remove the remaining backing paper as you apply the film. Work slowly to prevent wrinkles, creases and trapped air.

Step 6: Conform the Film

Apply gentle heat when necessary to soften the film and help it conform to bends, corners and lens contours. Avoid overheating or overstretching the material, as excessive heat or tension may affect the fitment and final appearance.

Step 7: Secure the Edges

Carefully inspect the perimeter of each overlay and firmly press down all edges. Apply light finishing heat where needed, then use the squeegee or your finger with a soft microfiber towel to secure the film.

Step 8: Inspect and Allow to Cure

Inspect both overlays for trapped air, wrinkles or unsecured edges. Allow the adhesive to set in a warm, dry environment. Avoid washing the vehicle or exposing the overlays to unnecessary moisture for at least 24 hours after installation.