Have questions?
Designed and tested in-house
We know our products
DIY friendly installation
Free USA Shipping over $49
If you're looking for a unique decal for your car and love the track inspired race decal look, look no further, simply type in your First Initial and Last name in the text box above and we'll make it for you. Simple and Easy to apply. Comes as a set, one for passenger side and one for the driver side. The American Flag is mirrored on one so it faces the correct way when placed on the opposite side. Unlike most ebay or amazon vendors, Premium Auto Styling vinyl overlays are designed and produced here in the USA in our own facility. We design and test fit all products to ensure fitment guaranteeing you the best results . Basically, if they don’t work on our cars, they’re not going to end up on yours. The approximate height of these decals is an 1.25 inches, and the length is dependent on the amount of characters entered in the test box.
TOOLS REQUIRED: PRO FELT SQUEEGEE
DRY INSTALL BASICS: Getting the vinyl installed on your vehicle is very easy and only requires minimal tools. For Best results we recommend cleaning the surface that you'll be applying our overlays too, cleaning should consist of removal of any waxes, dirt and or debris. For the cleaning process a clay bar is highly recommended: CLEANING PREP SPRAY & CLAY BAR's SOLD HERE). Before you begin installation of any vinyl overlays please make sure you are working in the right conditions, you should never install vinyl in direct sunlight, never apply vinyl in temperatures that are neither too hot nor too cold. Our in-house expert installers say the optimum temperature for installing vinyl is between 65 and 72 degrees (F). Vinyl can be installed in temperatures as low as 65 degrees (F), and up to 90 degrees (F). Vinyl has a more difficult time conforming and staying in place in colder temperatures though, which is why we recommend waiting until temperatures warm up or install in a temperature controlled environment.
NOTE: SURFACES TOO HOT OR TOO COLD AND EFFECT THE INSTALLATION OF THIS PRODUCT, READ ALL GUIDELINE RECOMMENDATIONS FOR BEST END RESULT.
FULL INSTALL: After the surface is clean and you have read and completed DRY INSTALL BASICS, Start with one corner of the transfer tape, and peel it away from the backing paper. If your decal doesn't separate from the backing paper lay the transfer tape back down, apply pressure to the top of the transfer tape in the area that the vinyl is not sticking and lift the transfer tape again. Now, place your decal and squeegee it down firmly into place, go over the entire decal with the squeegee. Then start from one corner and slowly peel the transfer tape back on it self. Pulling the transfer tape directly away from the surface may cause the vinyl to come up with it. If the transfer tape does not release the vinyl, lay it back into place, apply more pressure in that area and try again, continue this process until the vinyl is fully installed.
• Automotive Grade Adhesive backed vinyl with air release technology for easy installation and removal.
• Car wash safe.
• Can be removed without any damage to surface.
• 1-3 year life expectancy.
• Check your local laws and regulations
MORE >> Difficulty Rating Information
