2020–2022 Toyota C-HR Front Emblem Overlay | Carbon Stealth

Make the C-HR Emblem Yours

The Carbon Stealth finish gives the 2020–2022 Toyota C-HR a blacked-out emblem with a textured carbon fiber twist. It is a two-layer, pre-cut vinyl overlay that changes the look of the emblem without the hassle of removing the badge itself.

These overlays are made with quality automotive-grade vinyl — the same material we use to wrap entire vehicles, not the typical calendar film found in most decal stickers. Air release technology makes for an easy, bubble-free install, and the simple peel-and-stick process saves you time and money. Unlike most eBay or Amazon vendors, Premium Auto Styling vinyl overlays are designed and produced here in the USA in our own facility. We design and test-fit every product to ensure fitment — if it doesn't work on our cars, it doesn't end up on yours.

• Designed for 2020–2022 Toyota C-HR front radar emblems matching the product photos
• Automotive-grade adhesive-backed vinyl with air release technology
• Two-layer design — background and logo layers in one pre-cut overlay
• Applies over the existing front badge — no emblem removal required
• Car wash safe, and removable without damage to the emblem surface
• 1–3 year life expectancy
• Designed and produced in the USA by Premium Auto Styling

Vehicle Fitment

Designed for: 2020, 2021, and 2022 Toyota C-HR models equipped with the factory front radar emblem (Toyota Safety Sense) matching the configuration shown in the product images.

Sensor Compatibility: This overlay has been confirmed from our R&D vehicle that it does not affect the cruise control sensor in the emblem.

Disclaimer: By purchasing and installing this product, please be advised PREMIUM AUTO STYLING does not guarantee the function of collision sensors with use of this product. Buyer assumes all responsibility of any accident caused by use of this product. Although there have been no issues with any sensors, at all times, please drive carefully. All graphics, overlays, and pre-cuts are for offroad use only.

Installation Overview

1. Prepare the surface.
   You will need a pro felt squeegee and a heat gun (or a warm, sunny day for post-heating). Clean the emblem thoroughly, removing wax, dirt, and debris — a clay bar is highly recommended. Work out of direct sunlight, ideally between 65 and 72°F (vinyl can be installed from 65 to 90°F).
2. Align before you commit.
   Remove the vinyl from the backing paper, hold it by the left and right edges, and align it to the top, left, and right edges of the stock emblem. Set it in place lightly without pressing down — if the alignment is off, lift it and align again.
3. Squeegee the cross, then the corners.
   Starting at the center, use firm pressure with the felt squeegee to lay the vinyl vertically, then horizontally. Work each of the four corners outward from the center, one at a time, avoiding hard creases. A little heat helps relieve any tension. This emblem can be installed without heat — just be patient and do not rush.
4. Post-heat and inspect.
   Run the squeegee around the outer edge to tuck any excess — this product is cut so no trimming should ever be required. Post-heat by letting the vehicle sit in warm sun for about 30 minutes, or use a heat gun to speed up the process. Difficulty rating: 2 out of 5.

Frequently Asked Questions

Premium Auto Styling Support

Have questions about fitment or installation? Contact the Premium Auto Styling team in Riverside, California, for product guidance and professional installation options.