Have questions?
Designed and tested in-house
We know our products
DIY friendly installation
Free USA Shipping over $49
Changing up your fog lights to the classic rally yellow look couldn't be easier! This simple pre-cut tint overlay we have created takes out all the guess work, simply peel and stick. Unlike most ebay or amazon vendors, Premium Auto Styling vinyl and tint overlays are designed and produced here in the USA in our own facility. We design and test fit all products to ensure fitment guaranteeing you the best results . Basically, if they don’t work on our cars, they’re not going to end up on yours. If you are looking for an inexpensive styling modification, or you just want to change up the factory look, it's a great idea to checkout this vinyl overlay.
TOOLS REQUIRED: PRO FELT SQUEEGEE, HEAT GUN or Warm Sunny Day to Post Heat the product
WET INSTALL BASICS: Getting the vinyl installed on your ride is very easy and only requires minimal tools. First you need: lubrication spray solution. You can make a lubrication spray solution at home by using a spray bottle filled with water and mixing it with 1 drop of dish soap or buy our PRE-MIX SOLUTION SOLD HERE, You'll also need an application squeegee. For Best results we recommend cleaning the surface that you'll be applying our overlays too, cleaning should consist of removal of any waxes, dirt and or debris. For the cleaning process a clay bar is highly recommended: CLEANING PREP SPRAY & CLAY BAR's SOLD HERE). Before you begin installation of any vinyl overlays please make sure you are working in the right conditions, you should never install vinyl in direct sunlight, never apply vinyl in temperatures that are neither too hot nor too cold. Our in-house expert installers say the optimum temperature for installing vinyl is between 65 and 72 degrees (F). Vinyl can be installed as low as 50 degrees (F), and up to 90 degrees (F).
FULL INSTALL: After the surface is clean and you have read WET INSTALL BASICS, Mist the adhesive side of the overlay with the water solution, as well as the surface that it will be applied to. Line up the bottom edge and lay the overlay into place, starting from the center, using a squeegee, apply firm pressure laying the tint onto the surface moving outwards towards the edges. Continue to squeegee, removing any and all air and water from underneath the overlay. Depending on your placement of the overlay minimal trimming may be required. Post heat the overlay and the install is complete. No trimming required depending on your placement.
• Automotive Grade Adhesive backed vinyl with air release technology for easy installation and removal.
• Car wash safe.
• Can be removed without any damage to surface.
• 1-3 year life expectancy.
• Check your local laws and regulations
MORE >> Difficulty Rating Information
