Have questions?
Designed and tested in-house
We know our products
DIY friendly installation
Free USA Shipping over $49
The rear bumper reflectors are one of the easiest things you can change about the overall look of your camaro. You can fully black them out or just add smoke tint to give a darker red look. Simple peel and stick process makes for an easy DIY install anyone can do at home in their garage. Unlike most ebay or amazon vendors, Premium Auto Styling vinyl overlays are designed and produced here in the USA in our own facility. We design and test fit all products to ensure fitment guaranteeing you the best results . Basically, if they don’t work on our cars, they’re not going to end up on yours. If you are looking for an inexpensive styling modification, or you just want to change up the factory look without having to deal with opening up your tail light for internal modification, this is definitely the easiest route.
TOOLS REQUIRED: PRO FELT SQUEEGEE.
Gloss Black: Dry Install /// Smoke tint - Wet Install
PART 1 - INSTALL BASICS: Getting the vinyl installed on your vehicle is very easy and only requires minimal tools. For Best results we recommend cleaning the surface that you'll be applying our overlays too, cleaning should consist of removal of any waxes, dirt and or debris. For the cleaning process a clay bar is highly recommended: CLEANING PREP SPRAY & CLAY BAR's SOLD HERE). Before you begin installation of any vinyl overlays please make sure you are working in the right conditions, you should never install vinyl in direct sunlight, never apply vinyl in temperatures that are neither too hot nor too cold. Our in-house expert installers say the optimum temperature for installing vinyl is between 65 and 72 degrees (F). Vinyl can be installed in temperatures as low as 65 degrees (F), and up to 90 degrees (F). Vinyl has a more difficult time conforming and staying in place in colder temperatures though, which is why we recommend waiting until temperatures warm up or install in a temperature controlled environment.
PART 2: Once you have completed part one - install basics, you can move onto this step.
Dry Install: Start by peeling the vinyl off of the backing paper, line up the overlay to the outer sharper corner of the reflector, line up the top and bottom of the overlay, this will make everything else fall into place. Using a squeegee use firm pressure to adhere the vinyl to the surface of the reflector. Post heat with a heat gun or by leaving the vehicle in the sun for a couple hours and the Install is now complete.
Wet Install: Start by misting the surface of the reflector with a small amount of water then begin peeling the overlay off of the backing paper and mist the adhesive side of the tint, line up the overlay to the outer sharper corner of the reflector, line up the top and bottom of the overlay, this will make everything else fall into place. Using a squeegee use firm pressure to adhere the vinyl to the surface of the reflector starting from the center moving outwards until all moisture from underneath has been removed. Post heat with a heat gun or by leaving the vehicle in the sun for a couple hours and the Install is now complete.
• Automotive Grade Adhesive backed vinyl with air release technology for easy installation and removal.
• Car wash safe.
• Can be removed without any damage to surface.
• 1-3 year life expectancy.
• Check your local laws and regulations
MORE >> Difficulty Rating Information
