Have questions?
Designed and tested in-house
We know our products
DIY friendly installation
Free USA Shipping over $49
Looking for different ways to change up your hatchback without doing anything to drastic, these carbon fiber vinyl endplates cover the face of the end plate of the stock wing and accent it in a way that gives you a great spot to put other decals in that space. It definitely makes a visual difference on the lighter colored hatchbacks. It does take some vinyl experience during installation to avoid wrinkles but it's fairly easy to line up and with it being made out of quality wrap vinyl instead of sticker vinyl it is far more forgiving. Unlike most ebay or amazon vendors, Premium Auto Styling vinyl overlays are designed and produced here in the USA in our own facility. We design and test fit all products to ensure fitment guaranteeing you the best results . Basically, if they don’t work on our cars, they’re not going to end up on yours. If you are looking for an inexpensive styling modification, or you just want to change up the factory look, it's a great idea to checkout this vinyl overlay.
NOTE: This product was made for the stock XSE Wing ONLY, it was not made for the SE Wing or any Aftermarket wing.
TOOLS REQUIRED: PRO FELT SQUEEGEE, HEAT GUN or Warm Sunny Day to Post Heat the product
DRY INSTALL BASICS: Getting the vinyl installed on your vehicle is very easy and only requires minimal tools. For Best results we recommend cleaning the surface that you'll be applying our overlays too, cleaning should consist of removal of any waxes, dirt and or debris. For the cleaning process a clay bar is highly recommended: CLEANING PREP SPRAY & CLAY BAR's SOLD HERE). Before you begin installation of any vinyl overlays please make sure you are working in the right conditions, you should never install vinyl in direct sunlight, never apply vinyl in temperatures that are neither too hot nor too cold. Our in-house expert installers say the optimum temperature for installing vinyl is between 65 and 72 degrees (F). Vinyl can be installed in temperatures as low as 65 degrees (F), and up to 90 degrees (F). Vinyl has a more difficult time conforming and staying in place in colder temperatures though, which is why we recommend waiting until temperatures warm up or install in a temperature controlled environment.
FULL INSTALL: After the surface is clean and you have read and completed DRY INSTALL BASICS, line up the outer edge of the wing endplate, Start with the Corner (A) and Corner (B) as shown in the install diagram pictures above. Set this part in place first, while using it as an anchor point, align the (Outer Edge) while giving the vinyl a very slight pull so that Corner (A) is hooked into place which will make it easier to lay into place fully when you start to squeegee. At this point (A),(B) and Outer Edge should all be aligned, if done correctly Corner (C) should fall into place. Now start laying the material with a squeegee starting from the outer edge of the wing endplate working your way inwards, towards Corner (D). Move the squeegee length wise from Corner (A) to (C) gradually moving that line you are working towards Corner (D). This will be the last area to lay and may need some heat in order to relieve any tension you may end up with during the installation process. This is caused by the rounded nature of the wing endplate. Once completed make sure you have removed any and all air from underneath the vinyl with a final pass of the squeegee across the entire product. Then do the same with the heat gun. Your install is now complete.
• Automotive Grade Adhesive backed vinyl with air release technology for easy installation and removal.
• Car wash safe.
• Can be removed without any damage to surface.
• 2-5 year life expectancy.
• Check your local laws and regulations
MORE >> Difficulty Rating Information
