The trackhawk is already an aggressive looking vehicle. Now if you want to take it a step further, we've created a variety of products to do just that. This product in particular is a small subtle change that is very easy to install by yourself at home. This is a pre-cut piece of smoke tint that is made specifically for this make and model. Made to fit without an trimming required depending on your placement. Follow our install guide in the description for the best end result. This is an easy peal and stick tint accent overlay. Unlike most ebay or amazon vendors, Premium Auto Styling vinyl overlays are designed and produced here in the USA in our own facility. We design and test fit all products to ensure fitment guaranteeing you the best results . Basically, if they don’t work on our cars, they’re not going to end up on yours. If you are looking for an inexpensive styling modification, or you just want to change up the factory look, it's a great idea to checkout this vinyl overlay.  Check your local laws and regulations prior to purchasing. Disclaimer information attached below.

INSTALL GUIDE 

TOOLS REQUIRED: PRO FELT SQUEEGEE, HEAT GUN or Warm Sunny Day to Post Heat the product

WET INSTALL BASICS: Getting the vinyl installed on your ride is very easy and only requires minimal tools. First you need: lubrication spray solution.  You can make a lubrication spray solution at home by using a spray bottle filled with water and mixing it with 1 drop of dish soap or buy our PRE-MIX SOLUTION SOLD HERE, You'll also need an application squeegee. For Best results we recommend cleaning the surface that you'll be applying our overlays too, cleaning should consist of removal of any waxes, dirt and or debris. For the cleaning process a clay bar is highly recommended: CLEANING PREP SPRAY & CLAY BAR's SOLD HERE). Before you begin installation of any vinyl overlays please make sure you are working in the right conditions, you should never install vinyl in direct sunlight, never apply vinyl in temperatures that are neither too hot nor too cold. Our in-house expert installers say the optimum temperature for installing vinyl is between 65 and 72 degrees (F). Vinyl can be installed as low as 50 degrees (F), and up to 90 degrees (F).  

FULL INSTALL: After the surface is clean and you have read WET INSTALL BASICS, Mist the adhesive side of the overlay with the water solution, as well as the surface that it will be applied to. Line up the top edge of the overlay to the top edge of the third brake light, corner to corner. Lay the top flat portion by applying firm pressure across the surface with a squeegee, starting from the center moving outwards. Then, starting from the center again, lay the bottom portion of the light by squeegeeing starting from the top, motioning downwards until the overlay is completely installed. Continue to squeegee, removing any and all air and water from underneath the overlay. Post heat the overlay and the install is complete.

SUPERIOR QUALITY 

• Adhesive backed film for easy installation and removal.  

• Maintenance free & car wash safe. 

• Can be removed without any damage to surface. 

• 2-5 year life expectancy. 

• Check your local laws and regulations  

>> DISCLAIMER INFORMATION