2018-2020 Hyundai Elantra GT Hatchback - Tail Light Smoke Tint Overlay
NOTE: This product has only been tested and confirmed on the N-Line Hatchback Tail Lights.
With the introduction of the Elantra Hatch to the U.S. market, the possibilities for this platform seem almost endless. The OEM tail lights are a great starting point for modification if you're looking to make them stand out. Unlike most ebay or amazon vendors, Premium Auto Styling vinyl overlays are designed and produced here in the USA in our own facility. We design and test fit all products to ensure fitment guaranteeing you the best results . Basically, if they don’t work on our cars, they’re not going to end up on yours. If you are looking for an inexpensive styling modification, or you just want to change up the factory look, it's a great idea to checkout this vinyl overlay.
INSTALL GUIDE
TOOLS REQUIRED: PRO FELT SQUEEGEE, HEAT GUN
WET INSTALL BASICS: Getting the vinyl installed on your ride is very easy and only requires minimal tools. What you'll need: lubrication spray solution, squeegee and a heat gun. You can make a lubrication spray solution at home by using a spy bottle filled with water and mixing it with 1 drop of dish soap or buy our PRE-MIX SOLUTION SOLD HERE, You'll also need an application squeegee. For Best results we recommend cleaning the surface that you'll be applying our overlays too, cleaning should consist of removal of any waxes, dirt and or debris. For the cleaning process a clay bar is highly recommended: CLEANING PREP SPRAY & CLAY BAR's SOLD HERE). Before you begin installation of any vinyl overlays please make sure you are working in the right conditions, you should never install vinyl in direct sunlight, never apply vinyl in temperatures that are neither too hot nor too cold. Our in-house expert installers say the optimum temperature for installing vinyl is between 65 and 72 degrees (F). Vinyl can be installed as low as 50 degrees (F), and up to 90 degrees (F).
INSTALL GUIDE: After you have read and completed "WET INSTALL BASICS" continue with the following.
First mist the adhesive side of the overlay very lightly with surface lube (water soap solution) and then position the tint overlay into place on your vehicle's tail light. Position the overlay into place, once aligned, tack it down with a squeegee. Starting from the center of the piece you are working on, with a felt edge squeegee firmly push out the air, and any moisture from underneath the tint out to the edges. Do not push anything back towards the center. Everything needs to move outwards to prevent trapping any air or water. Once all air, and moisture has been removed, using a heat gun, post heat the material, tuck the edge around the inner side of the tail light. Installation complete.
SUPERIOR QUALITY
• Automotive Grade Adhesive backed vinyl with air release technology for easy installation and removal.
• Car wash safe.
• Can be removed without any damage to surface.
• 1-3 year life expectancy.
• Check your local laws and regulations
>> DISCLAIMER INFORMATION
DIFFICULTY RATING 3/5
MORE >> Difficulty Rating Information
