2015-2021 Subaru WRX / STI - Tail Light Insert With Custom Heart Cut Outs
This Custom vinyl overlay is for those of you who want to spread happiness everywhere you go. These cut-outs definitely give your tail light a custom look that typically you would only find from retro fitted tail lights but these are simple overlays that are made to fit this make and model specifically. There are a lot of options out there for the WRX and STI platform but we set out to create something different to give people another look, that they themselves could install on their vehicle. Along with a full install guide. This is an easy peal and stick tint accent overlay. Unlike most ebay or amazon vendors, Premium Auto Styling vinyl overlays are designed and produced here in the USA in our own facility. We design and test fit all products to ensure fitment guaranteeing you the best results . Basically, if they don’t work on our cars, they’re not going to end up on yours. If you are looking for an inexpensive styling modification, or you just want to change up the factory look, it's a great idea to checkout this vinyl overlay. Check your local laws and regulations prior to purchasing. Disclaimer information attached below.
INSTALL GUIDE
TOOLS REQUIRED: PRO FELT SQUEEGEE, HEAT GUN or Warm Sunny Day to Post Heat the product
WET INSTALL BASICS: Getting the vinyl installed on your ride is very easy and only requires minimal tools. First you need: lubrication spray solution. You can make a lubrication spray solution at home by using a spray bottle filled with water and mixing it with 1 drop of dish soap or buy our PRE-MIX SOLUTION SOLD HERE, You'll also need an application squeegee. For Best results we recommend cleaning the surface that you'll be applying our overlays too, cleaning should consist of removal of any waxes, dirt and or debris. For the cleaning process a clay bar is highly recommended: CLEANING PREP SPRAY & CLAY BAR's SOLD HERE). Before you begin installation of any vinyl overlays please make sure you are working in the right conditions, you should never install vinyl in direct sunlight, never apply vinyl in temperatures that are neither too hot nor too cold. Our in-house expert installers say the optimum temperature for installing vinyl is between 65 and 72 degrees (F). Vinyl can be installed as low as 50 degrees (F), and up to 90 degrees (F).
FULL INSTALL: After the surface is clean and you have read WET INSTALL BASICS, With the transfer tape attached, spray the adhesive side of the vinyl very lightly with surface lube and then position the vinyl into place on your vehicle. Take your tail light insert and line up the overlay with the tail light's outer edge that faces towards the trunk. Once aligned the rest of the overlay will fall into place. Using a squeegee, start from the center and begin pushing the air from beneath the overlay toward the edges. A heatgun is recommended to conform the edges of the overlay.Squeegee the material down. Remove the transfer tape. Post heat the product, and the installation is complete.
SUPERIOR QUALITY
• Adhesive backed film for easy installation and removal.
• Sold as a Pair - one overlay for each tail light
• Maintenance free & car wash safe.
• Can be removed without any damage to surface.
• 1-3 year life expectancy.
• Check your local laws and regulations
>> DISCLAIMER INFORMATION
DIFFICULTY RATING 1/5
MORE >> Difficulty Rating Information
