2016-2019 Honda Civic Coupe
Don't like the big eyesore that the clear section of the tail light has, easy fix, turn it into an aggressive accent on the car without sacrificing substantial light output. This pre-cut smoke tint overlay was created specifically for the coupe to do just that. While also keeping the install as easy as it gets, our install guide helps with placement and our guide below walks you through the wet install process. Unlike most ebay or amazon vendors, Premium Auto Styling vinyl and tint overlays are designed and produced here in the USA in our own facility. We design and test fit all products to ensure fitment guaranteeing you the best results . Basically, if they don’t work on our cars, they’re not going to end up on yours. If you are looking for an inexpensive styling modification, or you just want to change up the factory look, it's a great idea to checkout this vinyl overlay.
INSTALL GUIDE
TOOLS REQUIRED: PRO FELT SQUEEGEE, HEAT GUN or Warm Sunny Day to Post Heat the product, SHARP WRAP BLADE DEPENDING ON YOUR PRODUCT PLACEMENT.
WET INSTALL BASICS: Getting the vinyl installed on your ride is very easy and only requires minimal tools. First you need: lubrication spray solution. You can make a lubrication spray solution at home by using a spray bottle filled with water and mixing it with 1 drop of dish soap or buy our PRE-MIX SOLUTION SOLD HERE, You'll also need an application squeegee. For Best results we recommend cleaning the surface that you'll be applying our overlays too, cleaning should consist of removal of any waxes, dirt and or debris. For the cleaning process a clay bar is highly recommended: CLEANING PREP SPRAY & CLAY BAR's SOLD HERE). Before you begin installation of any vinyl overlays please make sure you are working in the right conditions, you should never install vinyl in direct sunlight, never apply vinyl in temperatures that are neither too hot nor too cold. Our in-house expert installers say the optimum temperature for installing vinyl is between 65 and 72 degrees (F). Vinyl can be installed as low as 50 degrees (F), and up to 90 degrees (F).
FULL INSTALL: After the surface is clean and you have read WET INSTALL BASICS, Mist the adhesive side of the overlay with the water solution, as well as the surface that it will be applied to. Line up the bottom edge and bottom corners to the tail light and the rest of the overlay falls into place. Lay the overlay into place, starting from the center, using a squeegee, apply firm pressure laying the tint onto the surface moving outwards towards the edges. Continue to squeegee, removing any and all air and water from underneath the overlay. Depending on your placement of the overlay minimal trimming may be required. Post heat the overlay and the install is complete. No trimming required depending on your placement.
FEATURES AND SPECIFICATIONS
• Automotive Grade Adhesive backed vinyl with air release technology for easy installation and removal.
• Car wash safe.
• Can be removed without any damage to surface.
• 1-3 year life expectancy.
• Check your local laws and regulations
>> DISCLAIMER INFORMATION
DIFFICULTY RATING: 2/5
MORE >> Difficulty Rating Information
