Select your vehicle

Tail Light Insert Overlay - Red Tint | 2012-17 Crosstrek XV / 2012-15 Impreza Wagon

Calculated at Checkout
  • Subaru Impreza & Crosstrek | Full Red Tail Light Tint Overlays
  • Red Tail Light Vinyl Overlays | Fits Subaru Crosstrek And Impreza
  • Subaru Impreza & Crosstrek | Full Red Tail Light Tint Overlays
  • Red Tail Light Vinyl Overlays | Fits Subaru Crosstrek And Impreza





  • Easy to install Pre Cut Tail Light Overlays \

  • Gloss red appearance / OEM tail light finish

  • 4 mil wrapping cast PVC vinyl material

  • Built-in protective clear coat layer for up to 8 years outdoor durability

  • Sold as set (Left & Right Side)

  • Pre-cut for ease of installation

  • Fits all 2012 - 2015 Impreza Wagon & Crosstrek



Accentuate the clean sculpted styling of your Impreza Lights with Premium Auto Styling's red tail light tint overlays (pre-cut). These overalys apply to the outside of the tail light for an impressive custom show car appearance. 

Perfect Fit Guaranteed. Premium Auto Styling vinyl designs have been test fit, refined, and tested again to assure a perfect fit every time. 

Premium Auto Styling uses only the highest quality 4 mil Wrapping Cast Vinyl available on the market today. Featuring a built-in protective clear coat layer this wrapping cast vinyl is designed to last at least 8 years of harsh outdoor weather. Making it far more durable than our competitors cheap, calendared vinyl film which starts to degrade in just a couple of months! 

Air release technology features miniature air channels on the adhesive side of the vinyl that allows air to easily be squeezed out from under for a bubble-free installation and a smooth wrinkle-free surface. 

Quick install guide: Getting the vinyl installed on your ride is very easy and only requires a spray bottle filled with a little soap and water and a squeegee. You’ll first want to spray the back side of the vinyl very lightly and then position it into place on the tail light. Use that squeegee to push out and remove any excess bubbles from underneath the vinyl, then leave your car in the sun for a few hours just to let everything dry, you can use a heat gun to speed up the drying process if you would like. This entire process should take you no more than 10 minutes to complete.  


 NOTE: Using a felt edge squeegee is highly recommended for this application. Available for purchase in our application tool section above. 

View AllClose

Additional Information

Product Designer::
Premium Auto Styling
Vinyl Brand Name::
Installation Difficulty::
View AllClose