2020 Hyundai Elantra GT N-Line Hatchback
One of the most drastic, yet smallest physical changes that can be done to your Elantra is this simple piece of vinyl. Pre-cut to wrap around the outer trim of the tail light to give it a much more aggressive sport styling appearance. Easy installation, peel and stick process, outlined in our product description makes this product very DIY friendly! The overlays are precision cut from a durable vinyl for a perfect fit and aggressive styling that’s sure to look good on your vehicle! Made from quality automotive vinyl.
NOTE: This product has only be tested on the GT (N-LINE) Hatchback. We do not have confirmation if the tails on the Regular GT, the R-Spec, the N, or the i30 are the same. Thus, we cannot confirm fitment for them at this time until this product has been tested on those vehicles. INSTALL GUIDE
TOOLS REQUIRED: PRO FELT SQUEEGEE
NOTE: IF YOU'VE PURCHASED THE TAIL LIGHT SMOKE TINT AS WELL AS THIS PRODUCT. WE RECOMMEND INSTALLING THE TINT FIRST AS IT WILL PROVIDE THE CLEANEST FINISH.
DRY INSTALL BASICS: Getting the vinyl installed on your vehicle is only requires minimal tools. For Best results we recommend cleaning the surface that you'll be applying our overlays too, cleaning should consist of removal of any waxes, dirt and or debris. For the cleaning process a clay bar is highly recommended: CLEANING PREP SPRAY & CLAY BAR's SOLD HERE). Before you begin installation of any vinyl overlays please make sure you are working in the right conditions, you should never install vinyl in direct sunlight, never apply vinyl in temperatures that are neither too hot nor too cold. Our in-house expert installers say the optimum temperature for installing vinyl is between 65 and 72 degrees (F). Vinyl can be installed in temperatures as low as 65 degrees (F), and up to 90 degrees (F). Vinyl has a more difficult time conforming and staying in place in colder temperatures though, which is why we recommend waiting until temperatures warm up or install in a temperature controlled environment.
FULL INSTALL: After the surface is clean and you have read and completed "DRY INSTALL BASICS" Start by peeling the vinyl from the backing paper while making sure not to stretch the vinyl or warp the edges. Start with the outer portion of the tail light, lining up the far corner that points towards the front of the vehicle. Once you have the vinyl aligned to the corner, everything else should fall right into place. Some positioning is required in order to line up the top and bottom edges. If the first corner you aligned was not right it will throw off the rest of the overlay. If you need to reposition your first corner, carefully lift the vinyl back up. During the alignment process you shouldn't be pushing the vinyl into place or squeegeeing it down just yet. Once the entire overlay is aligned you can use the squeegee to remove any and all air and moisture from underneath the vinyl.
Continue with the inner piece of the tail light starting with the inner corner. The ends of the vinyl overlay has a small amount of excess to tuck around the inner edges of the tail light. Again use the squeegee to remove any and all air and moisture from underneath the vinyl. Once complete, post heat the entire product or leave your vehicle outside in the warm sun for at least 30 minutes. Check to make sure you do not have any left over air pockets and your install is complete.
SUPERIOR QUALITY
• Includes driver and passenger side overlays ( total pieces included is 2).
• Automotive Grade Adhesive backed vinyl with air release technology for easy installation and removal.
• Car wash safe.
• Can be removed without any damage to surface.
• 1-3 year life expectancy.
• Check your local laws and regulations
>> DISCLAIMER INFORMATION
DIFFICULTY RATING 2/5 
Excited about your finished Product, let us know below! Take a picture while your at it, and let us know on instagram! @premiumautostyling /// Interested in a custom color or finish for this product. Contact our team at orders@premiumautostyling.com and we can look into your request before you place your order.
