

Have questions?
Designed and tested in-house
We know our products
DIY friendly installation
Free USA Shipping over $49
It's widely known that this is the way the Charger's rear end was intended to look from the beginning. We simply made it even easier for you to do it yourself at home. Premium Auto Styling smoked tint overlays add great styling for a low price! Our overlays are precision cut from a durable smoked vinyl for a perfect fit and aggressive styling that’s sure to look good on any color Charger! Made from quality smoked tint vinyl, application takes roughly 15-20 minutes to complete the entire project.
TOOLS REQUIRED: ***PRO FELT SQUEEGEE, and HEAT GUN or Warm Sunny Day to Post Heat the product
WET INSTALL BASICS: Getting the vinyl installed on your ride is very easy and only requires minimal tools. What you'll need: lubrication spray solution, squeegee. You can make a lubrication spray solution at home by using a spray bottle filled with water and mixing it with 1 drop of dish soap or buy our PRE-MIX SOLUTION SOLD HERE, You'll also need an application squeegee. For Best results we recommend cleaning the surface that you'll be applying our overlays too, cleaning should consist of removal of any waxes, dirt and or debris. For the cleaning process a clay bar is highly recommended: CLEANING PREP SPRAY & CLAY BAR's SOLD HERE). Before you begin installation of any vinyl overlays please make sure you are working in the right conditions, you should never install vinyl in direct sunlight, never apply vinyl in temperatures that are neither too hot nor too cold. Our in-house expert installers say the optimum temperature for installing vinyl is between 65 and 72 degrees (F). Vinyl can be installed as low as 50 degrees (F), and up to 90 degrees (F).
Once you have read and completed the "WET INSTALL BASICS" steps you can continue to the remaining portion of the install. Remember if you do not complete the Wet Install Basics before you continue you risk the end result of your install not looking its absolute best. Getting the vinyl installed on your Charger is very easy and only requires a spray bottle filled with a little soap and water and a felt edge squeegee. You’ll first want to spray / mist the back side of the vinyl very lightly and then position the overlays into place on the tail light. Using a squeegee push out and remove any excess bubbles from underneath the vinyl - Apply heat to the film to help mold the film around bends and curves. Once completed leave your car in the sun for a few hours just to let everything dry, you can use a heat gun to speed up the drying process if you would like. This entire process should take you no more than 15-20 minutes to complete.
CLICK HERE FOR DISCLAIMER INFORMATION