Have questions?
Designed and tested in-house
We know our products
DIY friendly installation
Free USA Shipping over $49
This roof wrap vinyl gives you just enough material along with some excess to be able to handle the outer edges of the material to properly glass your roof without any issue. A huge change you can make to the over all look of your mustang is definitely a roof wrap. Whether it be Gloss Black or Satin Black, either way it is a great first big wrap project to do with a friend. The material we will be sending to you for your project is the exact same automotive grade wrap film we use here at our own wrap shop. We don't send out sticker vinyl, which is extremely difficult to install without the air release technology and does not last anywhere near as long. Be sure to check out our thorough install video below to learn more about the installation process.
* PLEASE NOTE THAT ROOF WRAP KITS ARE ONLY SHIPPED AND SOLD TO U.S. CUSTOMERS. IF YOU PLACE AN ORDER AND ARE LOCATED OUTSIDE OF THE USA, WE WILL HAVE TO REFUND YOUR ROOF WRAP PURCHASE *
TOOLS REQUIRED: ***PRO FELT SQUEEGEE, and HEAT GUN or Warm Sunny Day to Post Heat the product
DRY INSTALL BASICS: Getting the vinyl installed on your vehicle is very easy and only requires minimal tools. For Best results we recommend cleaning the surface that you'll be applying our overlays too, cleaning should consist of removal of any waxes, dirt and or debris. For the cleaning process a clay bar is highly recommended: CLEANING PREP SPRAY & CLAY BAR's SOLD HERE). Before you begin installation of any vinyl overlays please make sure you are working in the right conditions, you should never install vinyl in direct sunlight, never apply vinyl in temperatures that are neither too hot nor too cold. Our in-house expert installers say the optimum temperature for installing vinyl is between 65 and 72 degrees (F). Vinyl can be installed in temperatures as low as 65 degrees (F), and up to 90 degrees (F). Vinyl has a more difficult time conforming and staying in place in colder temperatures though, which is why we recommend waiting until temperatures warm up or install in a temperature controlled environment.
FULL INSTALL: After the surface is clean and you have read and completed "DRY INSTALL BASICS" Remember this is NOT a WET install, Wrap material is installed dry. Now, with a friend, start by removing the vinyl from the backing paper without letting the adhesive side of the vinyl touch the ground or come in contact with debris before applying to the roof. Glass the material using the triangle method noted in the video tutorial below. Then continue with your pro-felt squeegee, and firm pressure until all air is removed from underneath the vinyl itself. Tuck outer edges carefully and trim excess material. Post heat the material and the install is complete.
• 55 x 60 inches of Material
• Automotive Grade Adhesive backed vinyl with air release technology for easy installation and removal.
• Car wash safe.
• Can be removed without any damage to surface if maintained properly.
• 2-5 year life expectancy. **based upon care of roof wrap
• Check your local laws and regulations
MORE >> Difficulty Rating Information
