Enhance the look of your 2025+ Toyota Camry with these smoked tint pre-cut reflector overlays! Designed specifically for the Camry SE, XSE, and XLE models (including Hybrid), these overlays provide a sleek, smoked appearance for your rear bumper reflectors.
Features:
- Perfect Fit: Compatible with 2025+ Toyota Camry SE / XSE / XLE / Hybrid rear bumper reflectors.
- Smoked Tint: Gives your reflectors a stylish, darkened look.
- High-Quality Material: Durable construction ensures 5-7 year lifespan, resisting all weather conditions.
- Nano Air-Release Technology: Made with high gloss material and nano air-release for easy, bubble-free application.
- Easy Peel-and-Stick Application: Simple to install; just peel and stick!
- Complete Set: Includes 2 pieces (left and right) for a complete smoke-out effect.
- Important Note: These are overlays, not replacements for the actual reflectors. They adhere directly onto your existing rear bumper reflectors.
Installation Instructions:
For best results, gather these tools: Heat Gun or Blow Dryer / Padded Glove or Felt Tip Squeegee.
- Prepare the Surface: Thoroughly clean the side mirror chrome trim with soap and water to remove any dirt or debris.
- Peel and Position: Carefully peel off the reflector overlays. Important: If you make a mistake, you can easily peel off the overlay and reposition it before applying heat.
- Alignment: Align the edge of the overlay towards the middle of the car.
- Application: Lay down the flat portion first, until the chrome trim splits into two sections. Apply either the top or bottom section first, allowing air to escape as you go.
- Guide and Smooth: Lay the remaining section, using a small amount of force to guide its placement. Slowly lay it down, pushing out any air bubbles as you smooth the overlay.
- Address Wrinkles: If wrinkles appear, gently lift the overlay and apply heat until the wrinkle disappears. Then, re-apply to the desired position.
- Trim Excess (If Necessary): If any excess vinyl extends beyond the reflector surface, carefully wrap it around the chrome trim, tuck it into crevices, or trim it off with a thin blade.
- Finalize Placement: Refer to the product photo for exact overlay placement.
- Adhesion: Once you're satisfied with the placement, post-heat the vinyl using a blow dryer or heat gun. This activates the adhesive and improves tackiness.
- Remove Bubbles: Firmly press any remaining bubbles with your finger and swipe them towards the nearest edge.
- Mistakes: If you make a mistake, simply peel off the overlay and apply heat to remove any wrinkles.
Remember to post-heat the vinyl after installation to ensure optimal adhesion!