2020 Hyundai Elantra GT N-Line Hatchback - License Plate Black Out 

Changing up the look of your hatch in a big way starts with this overlay, it is a subtle difference to some, but makes a huge difference overall. Made pre-cut to fit your GT N-Line without modification if installed correctly. Which is fairly easy, the overlay comes with pre-cut mounting points that make it easy to line up to the existing holes in the bumper under your license plate. This gloss black vinyl is not just sticker vinyl either, this is automotive grade wrap film, the same stuff we wrap entire vehicles with here at Premium Auto Styling. Unlike most ebay or amazon vendors, Premium Auto Styling vinyl overlays are designed and produced here in the USA in our own facility. We design and test fit all products to ensure fitment guaranteeing you the best results . Basically, if they don’t work on our cars, they’re not going to end up on yours. If you are looking for an inexpensive styling modification, or you just want to change up the factory look, it's a great idea to checkout this vinyl overlay.

INSTALL GUIDE 

TOOLS REQUIRED: PRO FELT SQUEEGEE, HEAT GUN or Warm Sunny Day to Post Heat the product

DRY INSTALL BASICS: Getting the vinyl installed on your vehicle is very easy and only requires minimal tools. For Best results we recommend cleaning the surface that you'll be applying our overlays too, cleaning should consist of removal of any waxes, dirt and or debris. For the cleaning process a clay bar is highly recommended: CLEANING PREP SPRAY & CLAY BAR's SOLD HERE). Before you begin installation of any vinyl overlays please make sure you are working in the right conditions, you should never install vinyl in direct sunlight, never apply vinyl in temperatures that are neither too hot nor too cold. Our in-house expert installers say the optimum temperature for installing vinyl is between 65 and 72 degrees (F). Vinyl can be installed in temperatures as low as 65 degrees (F), and up to 90 degrees (F). Vinyl has a more difficult time conforming and staying in place in colder temperatures though, which is why we recommend waiting until temperatures warm up or install in a temperature controlled environment.

FULL INSTALL: After the surface is clean and you have read and completed DRY INSTALL BASICS, take note that this product is fairly large and can be a lot of material to handle when placing. Be sure not to stretch or warp the overlay, it is pre-cut to sit into place perfectly when placed correctly. After removing it from the backing paper you want to make sure that the vinyl does not come in contact with any dirty surfaces or it will effect the finish of your end result.

Start by removing your license plate, then proceed to line up the rectangle cut outs in the middle of the vinyl overlay with the rectangle shaped cut outs in your rear bumper. Aligning these parts are vital to make this overlay sit correctly.

Now take your pro-felt squeegee and lay the middle of the vinyl overlay, the part between the two rectangles, starting from the center and move the squeegee with firm pressure top to bottom of the license plate area. Once completed your overlay should be locked into place, continue squeegeeing the vinyl material down starting from the center working your way out to the outer edges and the rest of the overlay should fall into place.

Post heat the overlay, simply by letting your vehicle sit out in the warm sun for approximately 30 minutes to an hour or use a heat gun.

SUPERIOR QUALITY 

• Automotive Grade Adhesive backed vinyl with air release technology for easy installation and removal.  

• Car wash safe. 

• Can be removed without any damage to surface. 

• 1-3 year life expectancy. 

• Check your local laws and regulations  

>> DISCLAIMER INFORMATION 

DIFFICULTY RATING 3/5

MORE >> Difficulty Rating Information